No need. We’ve added a parameter library in the software, once you find out what settings is best for a certain material;
you can record it in the parameter library. Next time you cut the same material, you just need to read it from the list.
Both ok, as long as your operating system is Windows XP/2000/Vista/7/8/10.
Our laser runs on Windows XP/2000/Vista/7/8/10 both 32bits and 64bits system.
But it does not run on Mac OS.
CorelDraw and AutoCAD are suggested. You can design all your artworks in these two software and then send to the RDWorksV8
software to set the parameters easily.
JPG, PNG, BMP, PLT, DST, DXF, CDR, AI, DSB, GIF, MNG, TIF, TGA,
PCX, JP2, JPC, PGX, RAS, PNM, SKA, RAW
Yes, you can take a photo by using a camera and then load the photo to the software directly and engrave it.
Yes, we welcome you to send us a file and we will make a sample for you to have a look.
Yes, you can start the software without laser machine.
The corner power should be less than the max power, since the laser head moves slower at corners. For how much less, it is best to do
some tests until you find the best one.
Yes, it’s ok to use files from Adobe Illustrator, but you will need to export it as DXF format. Then our software can load it directly.
Yes, it does support AI plug-in. However, at present, almost all Chinese Laser software cannot support AI plug-in very well. Sometimes
there’re some unknown problems if you use AI plug-in directly.
We would suggest you to export your AI files as DXF format, then our software can support it perfectly.
For CorelDraw X2, X3, X4, X5, X6, X7 our machine can support it directly.
DXF format, but there’s plug-in for coreldraw, so you can switch from coreldraw to our laser software directly.