The laser tube won’t fire the beam
Please make sure laser switch is on, then open lower left hand door panel (or back side door panel), check if the laser power supply is showing sign of receiving power — fans is running and power light is up, like below.
X-axis not moving at all
Locate on the left side of x-axis, please check if the wiring and roller lever of switch are well or not, like below.
Y-axis not moving at all
Here are the reasons: ● Rotary switch is turned on Note: The rotary-axis and y-axis can be switched, if the rotary switch is turned on, y-axis will not moving at all, and the rotary-axis will need to connect the rotary device. If it is “-”, please turn off to “O” and press the reset button […]
Alarm message of LCD panel—Machine protected
LCD panel shows the following information:
Alarm message of LCD panel—Water error
LCD panel shows the following information:
Alarm message of LCD panel—No enough extend space
For example, if you want to engrave a picture of 200×200mm, you move the laser head to the top left corner of the working table and press the “Origin” to set the starting point.
Alarm message of LCD panel—Frame/X/Y Slop over
If your laser cutter’s working area is 600×400mm, but you want to cut a graphic which larger than 600×400mm, this warn appears. Since the laser is not able to work beyond its working.
Why noisy while moving laser head front and back, how to adjust?
When you move laser head front and back, two couplings make a lot of noise.
The machine won’t turn on
If it’s pressed, please reset it, like below.
How to calibrate the working table to level.
There are three cases.
1. Two sides of the working table are not of the same height.
