My door is too narrow (only 80CM wide), how to move the laser cutter into my house?
As long as your door is wider than 740mm, you can divide your thunder laser cutter into two parts and pass your door without problem.
The computer can’t identify the laser cutting machine
If the software shows the below information:
Laser cutter has a wrong cutting/engraving size
If this problem occurs, generally the pulse setting of the X/Y axis motors is wrong.
Please follow the below steps to solve the problem
Why the starting point of a cutting graphic can’t meet with its end point
The problem is generally caused by two reason:
1. Belts of X axis and Y axis is loose:
Why the laser head hitting the boundary or the limit switch
There are three possibilities A. Wrong pulse setting If your laser cutter has a wrong pulse setting, the laser head might keep moving even it reaches the edge and hits the boundary. If that is the problem, you need to reset the pulse parameter to fix it. Please refer to the following link to reset […]
Laser cutter has no enough buffer distance
This problem only appears on the engraving mode.
For example, if you want to engrave a picture of 200x200mm, you move the laser head to the top left corner of the working table and press the “Origin” to set the starting point.
Laser cutter has a poor engraving quality/edge
If your laser cutter’s engraving quality is very poor, it has the following possibilities: A.Laser head is loose Please fasten the laser head as below B.The focus lens or the reflective mirrors are loose Please fasten the focus lens and the three reflective mirrors as below C.The material is loose Use some magnet or heavy […]
